I have a workflow many cells within it and I often get "Omniscope has run out of memory" errors for some of the blocks and all blocks below that become Stale.

To resolve this, I have to select "Update Stale" and the blocks will update, often resulting in a block further down the workflow to become stale, where I have to click "Update Stale" again and repeat this process 4-5 times to update the whole workflow.

It would be very convenient if Omniscope waits 5 seconds and runs the "Update Stale" automatically if there is a out of memory error when updating a block in DM - and to prevent an endless loop of this, stop and report an error after 3-5 attempts of updating stale blocks if Omniscope is still on the same block.